Your shopping cart is currently empty

Fluorescein di(β-D-galactopyranoside) is a fluorogenic substrate for β-galactosidase (λem=535 nm, λex=485 nm).

| Pack Size | Price | USA Warehouse | Global Warehouse | Quantity |
|---|---|---|---|---|
| 1 mg | $71 | - | In Stock | |
| 5 mg | $252 | - | In Stock | |
| 10 mg | $396 | - | In Stock |
| Description | Fluorescein di(β-D-galactopyranoside) is a fluorogenic substrate for β-galactosidase (λem=535 nm, λex=485 nm). |
| In vitro | Fluorescein di(β-D-galactopyranoside) exhibits time- and dose-dependent increases in fluorescence in Hs68 cells, with fluorescence levels generated by the dual-substrate method significantly lower than those produced by Fluorescein di(β-D-galactopyranoside)[1]. |
| Cell Research | Procedure 1. After the cells have been cultured to the appropriate state, add 2 mM Fluorescein di-beta-D-galactopyranoside to each well after adding an aliquot of the reaction buffer and store the plate at 37°C in the dark for 24 hours without supply of CO2. 2. Observe and capture images using a fluorescence microscope. The above information is based on published literature. Experimental procedures should be appropriately modified to meet specific research demands. |
| Synonyms | Fluorescein di(β-D-galactopyranoside), FDG |
| Molecular Weight | 656.59 |
| Formula | C32H32O15 |
| Cas No. | 17817-20-8 |
| Smiles | OC[C@H]1O[C@@H](Oc2ccc3c(Oc4cc(O[C@@H]5O[C@H](CO)[C@H](O)[C@H](O)[C@H]5O)ccc4C33OC(=O)c4ccccc34)c2)[C@H](O)[C@@H](O)[C@H]1O |
| Relative Density. | 1.74 g/cm3 |
| Storage | keep away from direct sunlight,store at low temperature | Powder: -20°C for 3 years | In solvent: -80°C for 1 year | Shipping with blue ice/Shipping at ambient temperature. | |||||||||||||||
| Solubility Information | DMSO: 5 mg/mL (7.62 mM), Sonication is recommended. | |||||||||||||||
Solution Preparation Table | ||||||||||||||||
DMSO
| ||||||||||||||||
Dissolve 2 mg of the compound in 100 μL DMSO
to obtain a stock solution at a concentration of 20 mg/mL . If the required concentration exceeds the compound's known solubility, please contact us for technical support before proceeding.
1) Add 100 μL of the DMSO
stock solution to 400 μL PEG300
and mix thoroughly until the solution becomes clear.
2) Add 50 μL Tween 80 and mix well until fully clarified.
3) Add 450 μL Saline,PBS or ddH2O
and mix thoroughly until a homogeneous solution is obtained.
| Size | Quantity | Unit Price | Amount | Operation |
|---|

Copyright © 2015-2026 TargetMol Chemicals Inc. All Rights Reserved.